Diabetes & Blood Pressure

mg/dL to mmol/L: Convert Glucose and Cholesterol Results

The same blood sugar can read 100 mg/dL on one report and about 5.6 mmol/L on another, because the unit has changed. This mg/dL to mmol/L conversion guide gives the factors for glucose, cholesterol, creatinine, BUN and triglycerides, shows the arithmetic, and names the mix-ups that make two correct numbers look like a disagreement.

Quick facts

  • Glucose: mg/dL divided by 18 gives mmol/L, the same as multiplying by about 0.0555.
  • Total, HDL and LDL cholesterol: mg/dL divided by 38.67 gives mmol/L.
  • Creatinine: mg/dL multiplied by 88.4 gives µmol/L, a unit one thousandth the size of mmol/L.
  • BUN: mg/dL multiplied by 0.357 gives mmol/L. A urea result printed on its own needs its own factor.
  • Rule of thumb: a conversion helps you read a number, and it never sets a dose or a diet target.

Prefer to listen? This post as a 2 min video · Watch the video

Why does the same blood sugar print as two different numbers?

Same blood, different scale. Blood sugar is a measure of how much glucose is dissolved in the blood. In mg/dL the number counts milligrams of glucose in each decilitre, a tenth of a litre, while in mmol/L it counts millimoles per litre, which tracks how many glucose molecules are present rather than their weight. One millimole of glucose weighs about 180 milligrams, so one litre at 1 mmol/L holds 180 mg, and a decilitre holds a tenth of that, which is 18 mg/dL and the reason the divisor is 18.

How do I convert glucose from mg/dL to mmol/L, step by step?

  1. Read the unit beside the number. If it says mg/dL, go on. If it already says mmol/L, you have the SI value and can skip the arithmetic.
  2. Divide by 18. For example, 126 mg/dL divided by 18 is 7.0 mmol/L.
  3. Check with the multiplier if you prefer it. Multiplying 126 by 0.0555 gives about 7.0 as well, so either route is fine.
  4. Round the way your lab rounds. Write the factor and the rounded value next to each other in your notes.
  5. Compare only with the lab’s own range column. Never compare with a chart from another lab or a website.

A fasting reading of 126 mg/dL is one of the diagnostic lines a doctor uses, and it converts to 7.0 mmol/L. An HbA1c of 6.5% is the other diagnostic line, and a doctor usually uses a second test to confirm it. HbA1c is reported as a percentage, and it does not use the glucose factor. Your doctor sets the targets, and the blood sugar level chart explains the bands.

What is the factor for cholesterol, creatinine, BUN and triglycerides?

Test (from mg/dL)FactorWorked example
Glucose to mmol/Ldivide by 18, or multiply by about 0.0555100 mg/dL is about 5.6 mmol/L
Cholesterol to mmol/Ldivide by 38.67200 mg/dL is about 5.2 mmol/L
Triglycerides to mmol/Ldivide by 88.57150 mg/dL is about 1.7 mmol/L
Creatinine to µmol/Lmultiply by 88.41.0 mg/dL is 88.4 µmol/L
BUN to mmol/Lmultiply by 0.35714 mg/dL is about 5.0 mmol/L

Labs round differently, and the last digit of a converted cholesterol value can change with the table used. Some tables write the glucose step as multiplying by 0.0555, and everyday guides divide by 18, which gives the same answer to rounding. Those differences are rounding, not a different reading of your blood, and the lab’s own converted value is the one to trust if it prints one.

A conversion explains a number. It never sets a target.

Why does the BUN factor differ from the urea factor?

BUN measures the nitrogen in urea, and the factor of 0.357 belongs to BUN. The NHANES laboratory data convert BUN in mg/dL to the SI value in mmol/L by multiplying by 0.357, which is why a BUN value of 14 mg/dL lands near 5.0 mmol/L. If your report prints urea itself rather than BUN, the number needs its own factor. This guide does not give a urea-only factor, because the lab’s note on the report is the safe source for it. Check the label first. Do not apply 0.357 by habit to a urea value.

The note beside the number

If a report prints one unit only, write the factor next to each converted value in your phone or notebook. Add the lab’s name and the date, so the next doctor can see exactly what was converted and how. Check the printed unit beside every value, then use that lab’s own range column. Ask the lab to confirm its rounding if the last digit matters to you.

Which mistakes make two correct results look different?

  • A converted value set against an mg/dL range. This error is common, and it makes a normal sugar look high or low when the units do not match.
  • Reading µmol/L as mmol/L. A creatinine of 88 µmol/L is about 1.0 mg/dL, but read as mmol/L it would look a thousand times larger.
  • Mixing BUN and urea. The two are linked, but they are not the same number, and one factor cannot stand in for the other.
  • Rounding that is applied twice. Converting a rounded value again can move the last digit.
  • Comparing across labs. Two labs can use different methods and ranges, which is a separate problem from the unit change.

Should I convert the numbers myself or ask the lab?

Convert to read a report, not to decide one, and ask the lab when a decision depends on the number. If a lab prints both units, use its values. If it does not, ask it to print both, which saves guesswork at the next visit. Blood pressure is the exception, since it is read as a pair of numbers and does not go through a unit conversion like these. The NHS puts high blood pressure at 140/90 or higher when checked by a healthcare professional, and at 135/85 or higher when checked at home. Sugar and cholesterol are different, so the conversion does not change what the doctor is looking for.

For the reasons two labs differ, and why their ranges are not comparable, read why two labs give different results and the normal range guide. Vitamin D reports use their own units, and they are covered in vitamin D report units. Conversions here are for reading only, and the category hub for this topic is Lab Reports Decoded, with diabetes and blood pressure in Diabetes & Blood Pressure.

Never change a medicine because of a converted number

Do not start, stop or change any diabetes or blood pressure medicine, or a diet plan, because of a converted value. Only your doctor reads the full picture. If someone with diabetes has shaking, sweating or confusion, check the sugar if you can. A reading below 4 mmol/L (about 72 mg/dL) needs something sugary to eat or drink straight away, such as a small glass of fruit juice, then a recheck after 10 to 15 minutes. If the person is unconscious, do not give food or drink, and call 999. Chest pain that does not go away, or chest pain with shortness of breath, needs 999 straight away. A blood pressure reading of 180/120 or more with symptoms such as chest pain is an emergency, so call your local emergency number.

Which unit questions do people ask about lab reports?

Blood sugar mg/dL to mmol/L: how is it converted?

Divide the mg/dL value by 18, or multiply by about 0.0555. For example, 100 mg/dL is about 5.6 mmol/L. Use the lab’s own converted value if it prints one, because rounding differs between labs.

Blood sugar mmol/L to mg/dL: how is it converted?

Multiply the mmol/L value by 18. For example, 5.5 mmol/L is about 99 mg/dL. Use the answer to read a report, not to set a target for yourself.

Cholesterol mg/dL to mmol/L: how is it converted?

Divide the mg/dL value by 38.67. For example, 200 mg/dL is about 5.2 mmol/L. Some tables round the divisor differently, so the last digit can differ, and the doctor reads the number with the other lipid results.

Creatinine mg/dL to µmol/L: how is it converted?

Multiply the mg/dL value by 88.4. For example, 1.0 mg/dL is 88.4 µmol/L. To go back, divide the µmol/L value by 88.4.

Why does one lab print 5.5 and another 5.6 for the same sugar?

Rounding. The conversion gives about 5.55 or 5.56 depending on the factor used, and different tables round that last digit up or down. The difference is too small to matter for reading, and the lab’s range is the one to compare against.

Is 100 mg/dL sugar the same as 5.6 mmol/L?

Yes, within normal rounding. Dividing 100 by 18 gives about 5.56, which rounds to 5.6. A converted number still needs your doctor to say what it means for you.

What is a normal sugar in mmol/L?

A conversion cannot tell you what is normal for you. Use the range printed on your own report, and the blood sugar chart article covers the target bands and the diagnostic lines.

Why do lab report units differ between reports?

Labs in different countries can report the same substance in different units, so the same blood can print as two different numbers. Ask the lab for both units rather than mixing units across reports.

What is the BUN to urea conversion?

BUN measures the nitrogen in urea, and the factor for BUN in mg/dL to mmol/L is 0.357. A urea result printed on its own uses a different factor, so check the lab’s note before converting it.

Does a converted number change a sugar or cholesterol target?

No. Targets come from your doctor and your overall risk, not from the unit. A converted value only shows the same number on another scale.

Mg dl kya hota hai?

mg/dL ka matlab hai har desilitre (ek litre ka das hissa) mein kitne milligram. mmol/L doosra scale hai, jisme same khoon ko molecules ki ginti ke hisaab se napa jata hai. Dono ek hi cheez ko napte hain, sirf unit alag hai.

Sources

Nothing on The Care Online is medical advice. Traditional practices are described as tradition, not as fact. Patch-test anything new, and take a persistent or serious concern to a qualified professional. See how posts are written on our methodology page.